One document matched: draft-ietf-gsmp-encaps-00.txt
GSMP Packet Encapsulations for ATM, Ethernet and TCP
<draft-ietf-gsmp-encaps-00.txt>
This document is an Internet-Draft and is in full conformance with
all provisions of Section 10 of RFC2026.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF), its areas, and its working groups. Note that
other groups may also distribute working documents as Internet-
Drafts.
Internet-Drafts are draft documents valid for a maximum of six
months and may be updated, replaced, or obsoleted by other
documents at any time. It is inappropriate to use Internet-
Drafts as reference material or to cite them other than as "work
in progress."
The list of current Internet-Drafts can be accessed at
http://www.ietf.org/ietf/1id-abstracts.txt
The list of Internet-Draft Shadow Directories can be accessed at
http://www.ietf.org/shadow.html.
Abstract
This memo specifies the encapsulation of GSMP packets in ATM,
Ethernet and TCP.
Worster Expires June 24th 2000 [Page 1]
Internet Draft GSMP Packet Encapsulations Jan 2000
1. Introduction
GSMP packets are defined in [1] and may be encapsulated in several
different protocols for transport. This memo specifies their
encapsulation in ATM AAL-5, in Ethernet or in TCP. Other
encapsulations may be defined elsewhere.
2. ATM Encapsulation
GSMP packets are variable length and for an ATM data link layer
they are encapsulated directly in an AAL-5 CPCS-PDU [3] with an
LLC/SNAP header as illustrated:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| LLC (0xAA-AA-03) | |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ +
| SNAP (0x00-00-00-88-0C) |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
~ GSMP Message ~
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Pad (0 - 47 octets) |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
+ AAL-5 CPCS-PDU Trailer (8 octets) +
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
(The convention in the documentation of Internet Protocols [4] is
to express numbers in decimal. Numbers in hexadecimal format are
specified by prefacing them with the characters "0x". Numbers in
binary format are specified by prefacing them with the characters
"0b". Data is pictured in "big-endian" order. That is, fields are
described left to right, with the most significant octet on the
left and the least significant octet on the right. Whenever a
diagram shows a group of octets, the order of transmission of
those octets is the normal order in which they are read in
English. Whenever an octet represents a numeric quantity the left
most bit in the diagram is the high order or most significant bit.
That is, the bit labelled 0 is the most significant bit.
Similarly, whenever a multi-octet field represents a numeric
Worster, et. al. Expires June 24th 1999 [Page 2]
Internet Draft GSMP Packet Encapsulations Jan 2000
quantity the left most bit of the whole field is the most
significant bit. When a multi-octet quantity is transmitted, the
most significant octet is transmitted first. This is the same
coding convention as is used in the ATM layer [1] and AAL-5 [3].)
The LLC/SNAP header contains the octets: 0xAA 0xAA 0x03 0x00 0x00
0x00 0x88 0x0C. (0x880C is the assigned Ethertype for GSMP.)
The maximum transmission unit (MTU) of the GSMP Message field is
1492 octets.
The virtual channel over which a GSMP session is established
between a controller and the switch it is controlling is called
the GSMP control channel. The default VPI and VCI of the GSMP
control channel for LLC/SNAP encapsulated GSMP messages on an ATM
data link layer is:
VPI = 0
VCI = 15.
3. Ethernet Encapsulation
GSMP packets may be encapsulated on an Ethernet data link as
illustrated:
Worster, et. al. Expires June 24th 1999 [Page 3]
Internet Draft GSMP Packet Encapsulations Jan 2000
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Destination Address |
| +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| | |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |
| Source Address |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Ethertype (0x88-0C) | |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+ |
| |
~ GSMP Message ~
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Sender Instance |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Receiver Instance |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Pad |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Frame Check Sequence |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Destination Address
For the SYN message of the adjacency protocol the
Destination Address is the broadcast address
0xFFFFFFFFFFFF. (Alternatively, it is also valid to
configure the node with the unicast 48-bit IEEE MAC
address of the destination. In this case the configured
unicast Destination Address is used in the SYN message.)
For all other messages the Destination Address is the
unicast 48- bit IEEE MAC address of the destination.
This address may be discovered from the Source Address
field of messages received during synchronisation of the
adjacency protocol.
Source Address
For all messages the Source Address is the 48-bit IEEE
MAC address of the sender.
Ethertype The assigned Ethertype for GSMP is 0x880C.
GSMP Message
The maximum transmission unit (MTU) of the GSMP Message
field is 1492 octets.
Worster, et. al. Expires June 24th 1999 [Page 4]
Internet Draft GSMP Packet Encapsulations Jan 2000
Sender Instance
The Sender Instance number for the link obtained from
the adjacency protocol. This field is already present in
the adjacency protocol message. It is appended to all
non- adjacency GSMP messages in the Ethernet
encapsulation to offer additional protection against the
introduction of corrupt state.
Receiver Instance
The Receiver Instance number is what the sender believes
is the current instance number for the link, allocated
by the entity at the far end of the link. This field is
already present in the adjacency protocol message. It is
appended to all non-adjacency GSMP messages in the
Ethernet encapsulation to offer additional protection
against the introduction of corrupt state.
Pad
The minimum length of the data field of an Ethernet
packet is 46 octets. If necessary, padding should be
added such that it meets the minimum Ethernet frame
size. This padding should be octets of zero and it is
not considered to be part of the GSMP message.
After the adjacency protocol has achieved synchronisation, for
every GSMP message received with an Ethernet encapsulation, the
receiver must check the Source Address from the Ethernet MAC
header, the Sender Instance, and the Receiver Instance. The
incoming GSMP message must be discarded if the Sender Instance and
the Source Address do not match the values of Sender Instance and
Sender Name stored by the "Update Peer Verifier" operation of the
GSMP adjacency protocol. The incoming GSMP message must also be
discarded if it arrives over any port other than the port over
which the adjacency protocol has achieved synchronisation. In
addition, the incoming message must also be discarded if the
Receiver Instance field does not match the current value for the
Sender Instance of the GSMP adjacency protocol.
4. TCP/IP Encapsulation
GSMP messages may be transported over an IP network using the TCP
encapsulation. TCP provides reliable transport, network flow
control, and end-system flow control suitable for networks that
may have high loss and variable or unpredictable delay. The GSMP
encapsulation in TCP/IP also provides sender authentication using
an MD5 digest.
Worster, et. al. Expires June 24th 1999 [Page 5]
Internet Draft GSMP Packet Encapsulations Jan 2000
For TCP encapsulations of GSMP messages, the controller runs the
client code and the switch runs the server code. Upon
initialisation, the server is listening on GSMP's (proposed) well
known port number. The controller establishes a TCP connection
with each switch it manages. Adjacency protocol messages, which
are used to synchronise the controller and switch and maintain
handshakes, are sent by the controller to the switch after the TCP
connection is established. GSMP messages other than adjacency
protocol messages may be sent only after the adjacency protocol
has achieved synchronisation.
4.1 Message Formats
GSMP messages are sent over a TCP connection. A GSMP message is
processed only after it is entirely received. A four-byte TLV
header field is prepended to the GSMP message to provide
delineation of GSMP messages within the TCP stream.
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type (0x88-0C) | Length |
|-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
~ GSMP Message ~
| |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Type
This 2-octet field indicates the type code of the
following message. The type code for GSMP messages is
0x00-0C (i.e. the same as GSMP's Ethertype).
Length: This 2-octet unsigned integer indicates the total length
of the GSMP message only. It does not including the 4-
byte TLV header.
4.2 Security consideration
To ensure the authenticity and security of GSMP messages which are
transported through an IP network standard security measures
should be used. GSMP provides for a two-layer security mechanism.
The first layer of security mechanism is applied to network layer
using IP-Sec (RFC 2401) [5].
Worster, et. al. Expires June 24th 1999 [Page 6]
Internet Draft GSMP Packet Encapsulations Jan 2000
5. Security Considerations
The security of GSMP's TCP/IP control channel has been addressed
in Section 4.2. Security over ATM and Ethernet must be provided at
the link layer. [need some more detail on minimum ip sec
requirements -- ed]
References
[1] T. Worster, "General Switch Management Protocol,"
Internet-Draft draft-ietf-gsmp-03, Jan 2000.
[2] "B-ISDN ATM Layer Specification," International
Telecommunication Union, ITU-T Recommendation I.361, Mar.
1993.
[3] "B-ISDN ATM Adaptation Layer (AAL) Specification,"
International Telecommunication Union, ITU-T
Recommendation I.363, Mar. 1993.
[4] Reynolds, J., and J. Postel, "Assigned Numbers," STD 2,
RFC 1700, October 1994.
[5] IP
Sec
[together with text above, ip sec refs -- ed]
Authors' Addresses
Tom Worster
Ennovate Networks
60 Codman Hill Rd
Boxboro MA 01719 USA
Tel +1 978-263-2002
fsb@thefsb.org
Worster, et. al. Expires June 24th 1999 [Page 7]
| PAFTECH AB 2003-2026 | 2026-04-24 03:41:24 |