One document matched: draft-haberman-ipngwg-mcast-arch-00.txt
IPNGWG Working Group B. Haberman
Internet Draft Nortel Networks
draft-haberman-ipngwg-mcast-arch-00.txt
December 1999
Expires June 2000
IP Version 6 Multicast Addressing Architecture
Status of this Memo
This document is an Internet-Draft and is in full conformance with all
provisions of Section 10 of RFC2026 [RFC 2026].
Internet-Drafts are working documents of the Internet Engineering Task
Force (IETF), its areas, and its working groups. Note that other groups
may also distribute working documents as Internet-Drafts. Internet-
Drafts are draft documents valid for a maximum of six months and may be
updated, replaced, or obsoleted by other documents at any time. It is
inappropriate to use Internet- Drafts as reference material or to cite
them other than as "work in progress."
The list of current Internet-Drafts can be accessed at
http://www.ietf.org/ietf/1id-abstracts.txt.
The list of Internet-Draft Shadow Directories can be accessed at
http://www.ietf.org/shadow.html.
Abstract
This specification defines the multicast addressing architecture of the
IP Version 6 protocol [RFC 2460]. The updated multicast address
architecture presented in this document allows for prefix-based
allocation of multicast addresses. It is an update of section 2.7 of
the RFC 2373 [RFC 2373].
1.
Terminology
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC 2119].
2.
Introduction
This document specifies an update to the IPv6 multicast addressing
architecture. The current architecture does not contain any built-in
support for dynamic address allocation. This proposal introduces
encoded information in the multicast address to allow for dynamic,
network prefix-based allocation of IPv6 multicast addresses.
3.
Multicast Address Format
Haberman 1
Internet Draft IPv6 Multicast Address Architecture December 1999
An IPv6 multicast address is an identifier for a group of nodes. A
node may belong to any number of multicast groups. Multicast addresses
have the following format:
| 8 | 4 | 4 | 8 | plen | 104 - plen |
+--------+----+----+--------+--------------------+--------------------+
|11111111|flgs|scop| plen | network prefix | group ID |
+--------+ +
---- ----+--------+--------------------+--------------------+
11111111 at the start of the address identifies the address as being a
multicast address.
+-+-+-+-+
flgs is a set of 4 flags: |0|0|P|T|
+-+-+-+-+
o
The high-order 2 flags are reserved, and must be initialized to
0.
o
P = 0 indicates a multicast address that is not assigned based
on the network prefix. When P = 0, the plen field and the
network prefix portion of the address are a part of the group
ID.
o
P = 1 indicates a multicast address that is assigned based on
the network prefix.
o
T = 0 indicates a permanently assigned (_well-known_) multicast
address, assigned by the global Internet numbering authority.
o
T = 1 indicates a non-permanently-assigned (_transient_)
multicast address.
scop is a 4-bit multicast scope value used to limit the scope of the
multicast group. The values are:
0 reserved
1 node-local scope
2 link-local scope
3 (unassigned)
4 (unassigned)
5 site-local scope
6 (unassigned)
7 (unassigned)
8 organization-local scope
9 (unassigned)
A (unassigned)
B (unassigned)
C (unassigned)
D (unassigned)
E global scope
F reserved
plen indicates the length of the network prefix embedded in the address
when P = 1. When P = 0, this field is considered a part of the group
ID.
network prefix identifies the network prefix of the unicast subnet
owning the multicast address. If P = 0, this field is considered a
part of the group ID. If P = 1, this field contains the unicast
network prefix defined in [RFC 2374] and assigned to the domain owning
the multicast address.
Haberman 2
Internet Draft IPv6 Multicast Address Architecture December 1999
group ID identifies the multicast group, either permanent or transient,
within the given scope.
The _meaning_ of a permanently assigned multicast address is
independent of the scope value. For example, if the _NTP servers
group_ is assigned a permanent multicast address with a group ID of 101
(hex), then:
FF01::101 means all NTP servers on the same node as the sender.
FF02::101 means all NTP servers on the same link as the sender.
FF05::101 means all NTP servers in the same site as the sender.
FF0E::101 means all NTP servers in the Internet.
Non-permanently-assigned multicast addresses are meaningful only within
a given scope. For example, a group identified by the non-permanent,
site-local multicast address FF15::101 at one site bears no
relationship to a group using the same address at a different site, or
to a non-permanent group using the same group ID with a different
scope, nor to a permanent group with the same group ID.
Multicast addresses must not be used as source addresses in IPv6
packets or appear in any routing header.
4.
Pre-Defined Multicast Addresses
The following well-known multicast addresses are pre-defined:
Reserved Multicast Addresses: FF00:0:0:0:0:0:0:0
FF01:0:0:0:0:0:0:0
FF02:0:0:0:0:0:0:0
FF03:0:0:0:0:0:0:0
FF04:0:0:0:0:0:0:0
FF05:0:0:0:0:0:0:0
FF06:0:0:0:0:0:0:0
FF07:0:0:0:0:0:0:0
FF08:0:0:0:0:0:0:0
FF09:0:0:0:0:0:0:0
FF0A:0:0:0:0:0:0:0
FF0B:0:0:0:0:0:0:0
FF0C:0:0:0:0:0:0:0
FF0D:0:0:0:0:0:0:0
FF0E:0:0:0:0:0:0:0
FF0F:0:0:0:0:0:0:0
The above multicast addresses are reserved and shall never be assigned
to any multicast group.
All Nodes Addresses: FF01:0:0:0:0:0:0:1
FF02:0:0:0:0:0:0:1
The above multicast addresses identify the group of all IPv6 nodes,
within scope 1 (node-local) or 2 (link-local).
All Routers Addresses: FF01:0:0:0:0:0:0:2
FF02:0:0:0:0:0:0:2
Haberman 3
Internet Draft IPv6 Multicast Address Architecture December 1999
FF05:0:0:0:0:0:0:2
The above multicast addresses identify the group of all IPv6 routers,
within scope 1 (node-local), 2 (link-local), or 5 (site-local).
Solicited-Node Address: FF02:0:0:0:0:1:FFXX:XXXX
The above multicast address is computed as a function of a node's
unicast and anycast addresses. The solicited-node multicast address is
formed by taking the low-order 24 bits of the address (unicast or
anycast) and appending those bits to the prefix
FF02:0:0:0:0:1:FF00::/104 resulting in a multicast address in the range
FF02:0:0:0:0:1:FF00:0000 to FF02:0:0:0:01:FFFF:FFFF.
For example, the solicited node multicast address corresponding to the
IPv6 address 4037::01:800:200E:8C6C is FF02::1:FF0E:8C:6C. IPv6
addresses that differ only in the high-order bits, e.g. due to multiple
high-order prefixes associated with different aggregations, will map to
the same solicited-node address thereby reducing the number of
multicast addresses a node must join.
A node is required to compute and join the associated Solicited-Node
multicast addresses for every unicast and anycast address it is
assigned.
5.
Assignment of New IPv6 Multicast Addresses
The current approach [RFC 2464] to map IPv6 multicast addresses into
IEEE 802 MAC addresses takes that low order 32 bits of the IPv6
multicast address and uses it to create a MAC address. Note that Token
Ring networks are handled differently. This is defined in [RFC 2470].
Group ID's less than or equal to 32 bits will generate unique MAC
addresses.
Due to this, new IPv6 multicast addresses that are not network prefix-
based should be assigned so that the group identifier is always in the
low order 32 bits as shown in the following:
| 8 | 4 | 4 | 80 bits | 32 bits |
+--------+----+----+------------------------------+-------------------+
|11111111|flgs|scop| reserved must be zero | group ID |
+--------+----+----+------------------------------+-------------------+
Any new IPv6 multicast addresses that are network prefix-based will
have the following format:
| 8 | 4 | 4 | 8 | plen bits | 72 _ plen | 32 bits |
+--------+----+----+--------+----------------+-----------+------------+
|11111111|flgs|scop| plen | Network prefix | reserved | group ID |
+--------+----+----+--------+----------------+-----------+------------+
While this limits the number of permanent IPv6 multicast groups to 2^32
this is unlikely to be a limitation in the future. If it becomes
necessary to exceed this limit in the future multicast will still work
but the processing will be slightly slower.
With the network prefix-based architecture and the current unicast
address architecture [RFC 2374], the network prefix portion of the
Haberman 4
Internet Draft IPv6 Multicast Address Architecture December 1999
multicast address will be at most 64 bits. This allows for the group
ID field to be 40 bits.
Additional IPv6 multicast addresses are defined and registered by the
IANA [RFC 2375].
6.
Security Considerations
This document does not have any direct impact on Internet
infrastructure security.
7.
References
[RFC 2026] S. Bradner, _The Internet Standards Process -- Revision 3_,
BCP 9, RFC 2026, October 1996.
[RFC 2460] S. Deering and R. Hinden, _Internet Protocol, Version 6
(IPv6) Specification_, RFC 2460, December 1998.
[RFC 2373] R. Hinden and S. Deering, _IP Version 6 Addressing
Architecture_, RFC 2373, July 1998.
[RFC 2119] S. Bradner, "Key words for use in RFCs to Indicate
Requirement Levels", RFC 2119, BCP14, March 1999.
[RFC 2374] R. Hinden, M. O'Dell, and S. Deering, _An IPv6
Aggregatable Global Unicast Address Format_, RFC 2374,
July 1998.
[RFC 2464] M. Crawford, _Transmission of IPv6 Packets over Ethernet
Networks_, RFC 2464, December 1998.
[RFC 2470] M. Crawford, T. Narten, and S. Thomas, _Transmission of IPv6
Packets over Token Ring Networks_, RFC 2470, December 1998.
[RFC 2375] R. Hinden and S. Deering, _IPv6 Multicast Address
Assignments_, RFC 2375, July 1998.
Haberman 5
Author's Address
Brian Haberman
Nortel Networks
4309 Emperor Blvd.
Suite 200
Durham, NC 27703
1-919-992-4439
Email : haberman@nortelnetworks.com
Haberman 6
| PAFTECH AB 2003-2026 | 2026-04-24 01:33:16 |