One document matched: draft-bernstein-pirp-01.txt

Differences from draft-bernstein-pirp-00.txt

Public Information Retrieval Protocol (PIRP)

INTERNET-DRAFT   draft-bernstein-pirp-01.txt   (expires 1 February 1997)

   This document is an Internet-Draft. Internet-Drafts are working
   documents of the Internet Engineering Task Force (IETF), its areas,
   and its working groups. Note that other groups may also distribute
   working documents as Internet-Drafts.

   Internet-Drafts are draft documents valid for a maximum of six
   months and may be updated, replaced, or obsoleted by other documents
   at any time. It is inappropriate to use Internet-Drafts as reference
   material or to cite them other than as ``work in progress.''

   To learn the current status of any Internet-Draft, please check the
   ``1id-abstracts.txt'' listing contained in the Internet-Drafts
   Shadow Directories on ftp.is.co.za (Africa), nic.nordu.net (Europe),
   munnari.oz.au (Pacific Rim), ds.internic.net (US East Coast), or
   ftp.isi.edu (US West Coast).

Status of this memo

   This memo provides information for the Internet community. This memo
   does not specify an Internet standard of any kind. Distribution of
   this memo is unlimited.

Abstract

   The Public Information Retrieval Protocol (PIRP) gives Internet hosts
   a simple, uniform, efficient, extensible, easily implemented method
   of publishing information. This document defines PIRP and outlines
   the structure of PIRP names.

   Unlike FTP and HTTP, PIRP is dedicated to publication. Implementing
   PIRP ought to be a small and trivial task.


Network Working Group                                       D. Bernstein
XXXXXXXXXXXXXXXXXXXX: NNNN                                            IR
Category: Informational                                   13 August 1996


              Public Information Retrieval Protocol (PIRP)


Status of this memo

   This memo provides information for the Internet community. This memo
   does not specify an Internet standard of any kind. Distribution of
   this memo is unlimited.


1. Introduction

   The Public Information Retrieval Protocol (PIRP) gives Internet hosts
   a simple, uniform, efficient, extensible, easily implemented method
   of publishing information. This document defines PIRP and outlines
   the structure of PIRP names.

   Unlike FTP and HTTP, PIRP is dedicated to publication. Implementing
   PIRP ought to be a small and trivial task.

   In this document, a string of 8-bit bytes may be written in two
   different forms: as a series of hexadecimal numbers between angle
   brackets, or as a sequence of ASCII characters between double quotes.
   For example, <68 65 6c 6c 6f 20 77 6f 72 6c 64 21> is a string of
   length 12; it is the same as the string "hello world!".


2. Protocol

   A PIRP client connects to a PIRP server, as discussed in section 5,
   over a reliable stream protocol allowing transmission of 8-bit bytes.

   The client sends a PIRP name. A PIRP name is a sequence of
   components. Each component is a string of 8-bit bytes. The final
   component is the empty string. Each previous component is nonempty.

   A PIRP name is encoded as the concatenation of the encodings of its
   components. Each component is encoded as a netstring, as discussed in
   section 4.












Bernstein                                                       [Page 1]

XXX NNNN         Public Information Retrieval Protocol       August 1996


   Here are three examples of encoded PIRP names:

      "6:finger,3:djb,0:,"
      "3:ftp,3:pub,8:software,17:qmail-0.90.tar.gz,0:,"
      "0:,"

   The reader should not conclude from these examples that PIRP names
   are required to be printable ASCII codes. The server must be prepared
   to accept arbitrary bytes from the client.

   After receiving the PIRP name from the client, the server normally
   returns information associated with the name. This information is a
   string of 8-bit bytes, encoded as a netstring. The server then closes
   the connection.

   Instead of returning an encoded component, the server may send the
   string "!", which may mean either ``There is no information
   associated with that name'' or ``I refuse to give you the information
   associated with that name.''

   Further server responses, beginning with a byte different from "!"
   and from the ASCII digits, may be defined in the future. Any server
   response beginning with "x" is reserved for experimental use.

   The server may indicate temporary failure by closing the connection
   before sending a complete response, or even before reading everything
   from the client. However, the server must not begin a response before
   reading everything from the client.

   The client may close the connection before reading everything from
   the server.

   A PIRP session should take at most 1 hour. Both sides are expected to
   close the connection after this time.


3. Name interpretation

   It is natural to divide PIRP names into categories based on the first
   component. A document may identify a particular component---for
   example, "finger"---and supply rules for the use of names with that
   first component, as well as for the information conveyed by the
   server's response. The first-level PIRP namespace will always have
   lots of room for future extensions. Lower-level namespaces might also
   leave room for growth.

   The first component "experimental" is reserved for experimental use.







Bernstein                                                       [Page 2]

XXX NNNN         Public Information Retrieval Protocol       August 1996


   This document does not require that servers support any particular
   portion of the PIRP namespace. However, PIRP-over-TCP servers
   accessible through the Internet (see section 5) should not use any
   non-experimental portion of the PIRP namespace in any non-standard
   way.

   The server's response to a single PIRP name may be fixed for long
   periods of time, or it may change without human intervention. The
   server may give the same response to all clients or different
   responses to different clients.


4. Netstrings

   Any string of 8-bit bytes may be encoded as [len]":"[string]",".
   Here [string] is the string and [len] is a nonempty sequence of ASCII
   digits giving the length of [string] in decimal. The ASCII digits are
   <30> for 0, <31> for 1, and so on up through <39> for 9. Extra zeros
   at the front of [len] are prohibited: [len] begins with <30> exactly
   when [string] is empty.

   For example, the string "hello world!" is encoded as <31 32 3a 68
   65 6c 6c 6f 20 77 6f 72 6c 64 21 2c>, i.e., "12:hello world!,". The
   empty string is encoded as "0:,".

   [len]":"[string]"," is called a netstring. [string] is called the
   interpretation of the netstring.


5. Encapsulation

   PIRP may be used on top of TCP. A PIRP-over-TCP server listens for
   TCP connections on port 553.


6. Security considerations

   Is the name received by a PIRP server the same as the name sent by
   the client? Is the information received by the client the same as the
   information sent by the server? The answers depend on the security
   and reliability of the underlying communications mechanism. It is
   easy to subvert TCP, for example, so if PIRP is used over TCP, an
   attacker can subvert the client's request or the server's response.

   It is a good idea to use a secure link instead of TCP. Note, however,
   that one can safely transmit public information through an insecure
   link, if in the meantime a cryptographic hash of the information is
   sent through a secure link.






Bernstein                                                       [Page 3]

XXX NNNN         Public Information Retrieval Protocol       August 1996


   If PIRP is used over a secure, reliable communications link, the
   client will correctly receive the server's response to its request.
   Further security considerations depend on the client's use of this
   response, and are not addressed in this document.


Author's address

   D. J. Bernstein

   EMail:  djb@pobox.com











































Bernstein                                                       [Page 4]