One document matched: draft-richardson-6tisch-security-architecture-01.txt
Differences from draft-richardson-6tisch-security-architecture-00.txt
Network Working Group M. Richardson
Internet-Draft SSW
Intended status: Informational March 03, 2014
Expires: September 04, 2014
security architecture for 6top: requirements and structure
draft-richardson-6tisch-security-architecture-01
Abstract
This document details minimal layer-2 requirements for 6top use in
industrial settings, and a few options for accomplishing this. The
layer-2 mechanism is then extended to provide for per-node
authentication and authorization of the node/PCE communications.
This internet-draft is intended for later inclusion into the 6tisch
architecture document.
This might be the worst written internet draft yet. You have been
warned
Status of This Memo
This Internet-Draft is submitted in full conformance with the
provisions of BCP 78 and BCP 79.
Internet-Drafts are working documents of the Internet Engineering
Task Force (IETF). Note that other groups may also distribute
working documents as Internet-Drafts. The list of current Internet-
Drafts is at http://datatracker.ietf.org/drafts/current/.
Internet-Drafts are draft documents valid for a maximum of six months
and may be updated, replaced, or obsoleted by other documents at any
time. It is inappropriate to use Internet-Drafts as reference
material or to cite them other than as "work in progress."
This Internet-Draft will expire on September 04, 2014.
Copyright Notice
Copyright (c) 2014 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
Richardson Expires September 04, 2014 [Page 1]
Internet-Draft 6tisch-security March 2014
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Table of Contents
1. Introduction: security bootstrap requirements . . . . . . . . 2
2. Requirements Language . . . . . . . . . . . . . . . . . . . . 2
3. layer-2 security requirements . . . . . . . . . . . . . . . . 2
4. 6top/PCE security requirements . . . . . . . . . . . . . . . 2
5. leveraging layer-2 identities for layer-4 security . . . . . 3
6. option 1: The ZigBeeIP/PANA way . . . . . . . . . . . . . . . 3
6.1. Network Discovery . . . . . . . . . . . . . . . . . . . . 3
6.2. PANA protocol . . . . . . . . . . . . . . . . . . . . . . 4
6.3. Authorization . . . . . . . . . . . . . . . . . . . . . . 4
7. option 2: The WirelessHart/ISA100 way . . . . . . . . . . . . 4
8. Security Considerations . . . . . . . . . . . . . . . . . . . 5
9. Other Related Protocols . . . . . . . . . . . . . . . . . . . 5
10. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 5
11. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 5
12. Normative references . . . . . . . . . . . . . . . . . . . . 5
Author's Address . . . . . . . . . . . . . . . . . . . . . . . . 6
1. Introduction: security bootstrap requirements
2. Requirements Language
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in RFC 2119 [RFC2119].
3. layer-2 security requirements
As outlined in [I-D.ietf-roll-security-threats] there are a number of
threats in LLNs, and in RPL which are solved if there is layer-2
security. The requirement is therefore to provide keying for the
layer-2 security features: encryption and integrity protection.
In addition to serving to protect the routing traffic against
attacks, use of the layer-2 access control serves as adminission
control to the network. It is therefore part of the layer-2 join
process to authenticate the new node, as well as authorize it to join
the network. The admission control SHOULD be controlled by autonomic
certificates, see section X.
4. 6top/PCE security requirements
Richardson Expires September 04, 2014 [Page 2]
Internet-Draft 6tisch-security March 2014
In addition to authorization a node to join the network, the node
agree to provide authorization to a PCE in order for the 6top
protocol to run. This protocol, described in section X of 6tisch
architecture (this) document and in [6top], permits the PCE to
program a timeslot schedule into the node.
So, the second part of the 6tisch security requirements is to
establish the identities of the the node and the PCE, and to
establish an authorization that permits the new node to be programmed
by the PCE.
5. leveraging layer-2 identities for layer-4 security
As explained in [I-D.behringer-autonomic-network-framework] the
layer-2 identity of the node will be given by a certificate signed by
the vendor of the node. The vendor's certificate authority is loaded
into the (PANA) Authorization Server, and permits the AS to
authenticate the node.
The vendor provides a certificate (chain) to the (PANA) Authorization
Server (PAS) attesting to that the PAS is the rightful owner/
controller of the node. This permits the node to validate that the
network it is joining is the correct network. This process permits
the bootstrap of one of the layer-2 security mechanism(s) describe in
sections below.
The same set of trust relationships can then permit the PAS to act as
an Authorization Server (now, in the context of
[I-D.gerdes-core-dcaf-authorize]). The PCE and it's Authorization
Manager (AM, again from [I-D.gerdes-core-dcaf-authorize]) can now get
a ticket to permit it to write the timeslot schedule. In option 2,
below, it also permits updates to the security parameters.
6. option 1: The ZigBeeIP/PANA way
This is an adaptation of the process described in [ZigBeeIP], section
and expounded upon in section 6.3: "Network Discovery", 6.4: "Network
Selection", and 6.5, "Node Joining". The process is abridged below.
6.1. Network Discovery
The MAC beacon facility is used. A critical difference in 6tisch
from ZigBee IP is that because nodes transmit and receive according
to their own schedule, every node is in essence a coordinator. While
nodes may sleep a lot, they will not in general be sleep Hosts, from
a ZigBee IP point of view, and MLE is not necessary.
Each response to the Beacon is a potential network-joining-parent.
Richardson Expires September 04, 2014 [Page 3]
Internet-Draft 6tisch-security March 2014
As an option, it may be desireable for this document to define a well
known NetworkID.
6.2. PANA protocol
The PANA payloads MUST be relayed by the chosen network-joining-
parent. It is assumed that the PANA Authentication Agent is co-
located with the PCE, if there is a PCE.
As per section 8.3.4 of [ZigBeeIP], the PANA process runs over UDP
using link-layer addressing. The process is first the PANA
initialization (PCI, PAR:S, PAN:S), followed by EAP initialization
(EAP-Request, EAP-Response), which negotiates the identity, and then
EAP-TLS starts, consisting of (TLS(Start), TLS(ClientHello),
TLS(ServerHello), TLS(ServerKeyExchange), TLS(ClientKeyExchange), and
TLS(ChangeCipherSpec)).
When the TLS is done, the EAP derives new network security material,
and sends it encrypted using the Encr-Encap AVP described in
[RFC6786].
6.3. Authorization
QUESTION: can we find a way for the authorization protocol, such as
described in draft-gerdes-core-dcaf-authorize-01, to run
simultaenously with the authentication system if we assume that the
dcaf AS is also the PANA Authentication Server/Agent
In the context of draft-selander-core-access-control, the new node
that is joining is the resource server, and the origin client is the
PCE.
7. option 2: The WirelessHart/ISA100 way
This is an adaptation of the process described in [HART], section
6.6.3.
In this process, the new node joins using a well-known layer-2 "JOIN"
key. It brings up the layer-3, using 6loWPAN Neighbour Discovery to
learn of the 6lowpan contexts, and then uses RPL to join a well-known
DODAG as a leaf node.
Nodes which have capacity for new joining nodes will respond to the
RPL DIS messages. Once connected, the new node uses regular
unicasted IP datagrams to contact an Authorization Manager (in the
context of [I-D.gerdes-core-dcaf-authorize]). The negotiation with
the Authorization Manager (AM) uses the autonomic certificates as
described above to establish the trust relationship.
Richardson Expires September 04, 2014 [Page 4]
Internet-Draft 6tisch-security March 2014
Once the relationship is up, the AM needs to signal the PCE that it
has a new authorized node, and the PCE can now (acting as a
[I-D.gerdes-core-dcaf-authorize] Client), get a Ticket to update the
node.
The PCE then writes both a new timeslot schedule, and also writes new
security parameters that permit the node to fully join the network.
Appropriate layer-2 keys are updated, as well as any appropriate
layer-3 RPL credentials. MLE may be used to establish pair-wise
keying, as appropriate to the timeslot schedule.
8. Security Considerations
9. Other Related Protocols
10. IANA Considerations
11. Acknowledgements
12. Normative references
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[ZigBeeIP]
ZigBee Public Document 15-002r00, "ZigBee IP
Specification", 2013.
[RFC6786] Yegin, A. and R. Cragie, "Encrypting the Protocol for
Carrying Authentication for Network Access (PANA)
Attribute-Value Pairs", RFC 6786, November 2012.
[I-D.ietf-roll-security-threats]
Tsao, T., Alexander, R., Dohler, M., Daza, V., Lozano, A.,
and M. Richardson, "A Security Threat Analysis for Routing
Protocol for Low-power and lossy networks (RPL)", draft-
ietf-roll-security-threats-06 (work in progress), December
2013.
[I-D.behringer-autonomic-network-framework]
Behringer, M., Pritikin, M., Bjarnason, S., and A. Clemm,
"A Framework for Autonomic Networking", draft-behringer-
autonomic-network-framework-01 (work in progress), October
2013.
[I-D.gerdes-core-dcaf-authorize]
Gerdes, S., Bergmann, O., and C. Bormann, "Delegated CoAP
Authentication and Authorization Framework (DCAF)", draft-
Richardson Expires September 04, 2014 [Page 5]
Internet-Draft 6tisch-security March 2014
gerdes-core-dcaf-authorize-02 (work in progress), February
2014.
[HART] www.hartcomm.org, "Highway Addressable Remote Transducer,
a group of specifications for industrial process and
control devices administered by the HART Foundation", .
[ISA100.11a]
ISA, "ISA100, Wireless Systems for Automation", May 2008,
< http://www.isa.org/Community/
SP100WirelessSystemsforAutomation>.
Author's Address
Michael C. Richardson
Sandelman Software Works
470 Dawson Avenue
Ottawa, ON K1Z 5V7
CA
Email: mcr+ietf@sandelman.ca
URI: http://www.sandelman.ca/
Richardson Expires September 04, 2014 [Page 6]
| PAFTECH AB 2003-2026 | 2026-04-20 12:52:41 |